KC868 server

[fdcemb5]

if I connect DS18B20/DHT11/21 Temperature and humidity sensor to these pins, how do I make it appear in Home Assistant since I cannot write Arduino code on KC868 server

GPIO-1: GPIO4
GPIO-2: GPIO5
GPIO-3: GPIO18
GPIO-4: GPIO19

[admin]

you can config by esphome, these gpios manager by ESP32.

[fdcemb5]

Kindly point to me to how this is achieved

[admin]

here is video tour about it: https://www.kincony.com/forum/showthread.php?tid=1826