KC868-A*S v2 relay assignment issue

[TerryAU]

Hello Everyone, 
I have KC868-A8S v2. 

I'm running Tasmota 10.0.0.3, and it appears the switch and relay assignments could be printed wrong? 

When I move the physical switch on the unit it triggers the wrong relay. 

Switch 1 - Relay 8
Switch 2 - Relay 7
Switch 3 - Relay 6
Switch 4 - Relay 5
Switch 5 - Relay 4
Switch 6 - Relay 3
Switch 7 - Relay 2 
Switch 8 - Relay 1

Very confusing, but I'm wondering if tasmota has caused the issue, or is the printing on the unit incorrect? 


If I activate a relay through Tasmota, the correct relay is triggered. 

[admin]

i can't see your photo. suggest you download KCS firmware firstly, test with KCS, if it's OK, that mean hardware PCB is no problem. Then check with your tasmota setting.

[TerryAU]

After the WhatsApp chat, seems this is the case.

It's the way the unit is manufactured.

Tasmota - Trigger relay 1 = Relay 1
Tasmota - Trigger relay 2 = Relay 2
...
Tasmota - Trigger relay 3 = Relay 3

Using the switch on the unit.

K1 = Trigger relay 8
K2 = Trigger relay 7
...
K7 = Trigger relay 2
K8 = Trigger relay 1

[admin]

yes.