KC868-A32 wiring diagram

[KinCony Support]

   

[shuhrat]

Which pin to connect the ds18b20 temperature sensor to?

[admin]

if you want connect DS18B20, you can connect to extend serial port GPIO on the PCB.

[johnsmith8439]

Good day,
How do I output 12/24V for LED? Just replace light bulb in the diagram with 12/24V power supply and LED?

[admin]

yes, you are right.

[johnsmith8439]

Thank you very much.

[johnsmith8439]

Hello,
How should I wire an AC-AC contactor? Do I need RC Snubber? I want to control a 20A water heater. Thank you every much.

[admin]

if you want to use AC-AC contactor, just let A32's relay output AC220V to contactor's coin. KC868-A32 designed PCB can work without RC snubber.

[johnsmith8439]

Is the screws terminal for this board 3.81mm or 5.08mm? I mean something like this:
https://www.aliexpress.com/item/1005007634896358.html
In my project the wires have to come in from the side.
I want to know if 3.81mm or 5.08mm will fit on A32. Thank you very much.

[admin]

if you are asking relay output green terminal, it's 5.00mm, NOT 5.08mm.