Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
ESP32 input problem from contacts of Thermal-magnetic circuit breaker
#1
Hi
I am designing a pressure controlled vacuum tank.
Software of ESP32 and
Nextion screen is OK

But I have problem when
I get digital input from (TMCB)
thermal magnetic circuit protector( schneider gv2me14)
When red fault contacts close I want to get information of fault of motor.  But esp32 reset itself .


Attached Files Image(s)
   
Reply
#2
do you have connect the detect signal port to ESP32's GPIO directly? Is there an optocoupler isolation circuit?
Reply
#3
No I don't use optocoupler
Would you advise optocoupler module or any other product ?
Reply
#4
maybe your contactor have interference signal.
Reply


Forum Jump:


Users browsing this thread: