button switch module for KC868-Hx

[Dm81]

As I wrote in my other post, I connected the push button switch module to rs232 to the LAN converter, I would know if it is possible to change the push button switch module firmware to get a message every time I press and leave a contact from the input like in your video (https://www.kincony.com/momentary-latch-...n-diy.html)
If I press and hold a button I receive RELAY-KEY-255, X, 1,
If I release the button I receive RELAY-KEY-255, X, 0

do you think is possible?
thank you in advance

[admin]

switch terminal board designed by 8051 CPU, write by C program code. we can't change the firmware because many people is using. if you want to do this have you can try to modify the C code, we can send you the "switch terminal board" source code. you just change it , compile it and download to CPU by RS232.

[Dm81]

switch terminal board designed by 8051 CPU, write by C program code. we can't change the firmware because many people is using. if you want to do this have you can try to modify the C code, we can send you the "switch terminal board" source code. you just change it , compile it and download to CPU by RS232.

yes, please
I would appreciate it very much

[admin]

here is project source code, if you modify complete, you can upload share with other users when they want to use, thanks.


  switch-terminal-board-source-code.zip (Size: 107.84 KB / Downloads: 241)

[Dm81]

here is project source code, if you modify complete, you can upload share with other users when they want to use, thanks.

if it will works, of sure, thx

[admin]

just modfiy a little code will realize the function you want.

[Dm81]

just modfiy a little code will realize the function you want.

I would but I need to ask help to a friend because I don't know C

[admin]

good luck.