I-O testing board

[Olsen@HuaHin]

Hi

I received my KC868-A16 board last week and are at the moment testing I-O before starting to write any Arduino code.

My firmware is the latest version 1.0.19

I can from the web portal activate each output, but I cannot see any incoming inputs and they will not toggle assigned output.

I am using the 12v dc from your supplied power supply and I connected GND to input terminals.

Any idea what I am doing wrong.

[admin]

your wire is wrong.
every Digital input short with GND = trigger.
how to trigger see "yellow" wire in image.
   

[Olsen@HuaHin]

I had expected a trigger of 12vdc according to specifications.

Anyway, thanks for the clarification 

[admin]

because your cable always connect with dc12v, that means NOT trigger. INPUT with GND is trigger.