10-16-2023, 04:58 AM
new KC868-HA plugin released: https://www.kincony.com/forum/showthread.php?tid=3397
|
KC868-HA RS485 Button Adapter Released
|
10-16-2023, 07:36 AM
(10-16-2023, 04:58 AM)admin Wrote: new KC868-HA plugin released: https://www.kincony.com/forum/showthread.php?tid=3397Super ! Thank you for this productive weekend ;-))
10-16-2023, 12:22 PM
Hi,
Is it possible to use 4x KC868-A16 and 10+ on the same modbus (RS485) line? I want to use the KCS firmware Also greetings from Belgium :-) @NicThemodder if you want to come together sometime to show installations/share info/tips/tricks?
10-16-2023, 11:08 PM
can you draw a diagram post at here.
do you want multi KC868-A16 connect together with RS485, control by PC or another device? sorry, i don't understand what you want to do.
10-17-2023, 08:59 AM
(10-16-2023, 11:08 PM)admin Wrote: can you draw a diagram post at here. So all devices on 1 data + power line. and bind HA 1,2 to KC868-A16-1, 3-5 to KC868-A16-2, 6 to KC868-A16-3 and 7-10 to KC868-A16-4. I don't want to hardwire them individually. I just want to use the current utp and put 12v on orangewhite/orange and RS485 on bluewhite/blue and connect all the wires of all the HA and A16 together.
10-17-2023, 10:21 AM
sure, it can work, because every KC868-HA can set different RS485 address by PC config software. every KC868-A serles relay board can set different RS485 address by config webpage via KCS firmware.
10-31-2023, 08:20 PM
(10-17-2023, 08:59 AM)Dario Wrote:(10-16-2023, 11:08 PM)admin Wrote: can you draw a diagram post at here. Dario, RS485 - (Modbus) is a line that goes from point to point, not in a star! If you have a long line, you need to terminate them with a 120 Ohm resistor (jumper on the kc868-HA board) |
|
« Next Oldest | Next Newest »
|
| Users browsing this thread: |
| 1 Guest(s) |