Hi,
Would this board be suitable to control a small DC motor (I want to automate the chicken coop door).
Which motor controller would be suitable and can I just connect it to the GPIO pins in the green terminals?
Can I also connect Hall effect sensor to detect open/closed state of the door?
I believe ESP32 has built-in support for hall effect?
sorry, still quite new to electronics/esp32 but therefore I'm looking at this nice board instead of starting from scratch.
Appreciate the advice.
Regards,
Nick
Would this board be suitable to control a small DC motor (I want to automate the chicken coop door).
Which motor controller would be suitable and can I just connect it to the GPIO pins in the green terminals?
Can I also connect Hall effect sensor to detect open/closed state of the door?
I believe ESP32 has built-in support for hall effect?
sorry, still quite new to electronics/esp32 but therefore I'm looking at this nice board instead of starting from scratch.
Appreciate the advice.
Regards,
Nick