Smart Home Automation Forum › Technical Support › KC868-Server Raspberry Pi4 local server v
how-to config ymal for work rs485

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
how-to config ymal for work rs485
admin Offline
Administrator
*******
Posts: 6,180
Threads: 802
Joined: Oct 2020
Reputation: 151
#10
04-01-2024, 10:53 AM
GPIO1,GPIO2,GPIO3,GPIO4 just GPIO with ESP32, it's not RS485 interface. if your device is RS485, you should connect with "ORANGE" terminal RS485 port.
YouTube: https://www.youtube.com/c/KinCony
Online Store: https://kincony.aliexpress.com
Find
Reply


Messages In This Thread
how-to config ymal for work rs485 - by itzek - 03-26-2024, 11:24 PM
RE: how-to config ymal for work rs485 - by admin - 03-27-2024, 12:08 AM
RE: how-to config ymal for work rs485 - by itzek - 03-28-2024, 02:34 PM
RE: how-to config ymal for work rs485 - by admin - 03-28-2024, 10:23 PM
RE: how-to config ymal for work rs485 - by itzek - 03-31-2024, 10:28 AM
RE: how-to config ymal for work rs485 - by admin - 03-31-2024, 12:30 PM
RE: how-to config ymal for work rs485 - by itzek - 03-31-2024, 01:59 PM
RE: how-to config ymal for work rs485 - by admin - 03-31-2024, 10:22 PM
RE: how-to config ymal for work rs485 - by itzek - 04-01-2024, 08:53 AM
RE: how-to config ymal for work rs485 - by admin - 04-01-2024, 10:53 AM
RE: how-to config ymal for work rs485 - by itzek - 04-01-2024, 12:49 PM
RE: how-to config ymal for work rs485 - by admin - 04-01-2024, 10:27 PM
RE: how-to config ymal for work rs485 - by itzek - 04-02-2024, 06:44 AM

Forum Jump:


Users browsing this thread:
1 Guest(s)