04-18-2024, 09:15 PM
I added tuya adapter, and I created a scene (if relay1-ON then relay2-OFF)&(If relay2-ON then relay1-OFF).
But I noticed that there is a small problem:
For example, when i turn on relay1, and I turn on relay2, then relay1 turn OFF after less than a second!! But in this small period of time, the motor will get electricity for both directions UP&DOWN, and it’s not good for the motor!!
Is there any solution to minimize this time for relay1 changing status?
But I noticed that there is a small problem:
For example, when i turn on relay1, and I turn on relay2, then relay1 turn OFF after less than a second!! But in this small period of time, the motor will get electricity for both directions UP&DOWN, and it’s not good for the motor!!
Is there any solution to minimize this time for relay1 changing status?