Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
how to connect KC868 to home assistant
#8
(06-16-2024, 10:29 PM)admin Wrote: if you want use A16 with home assistant, just use our ESPHome yaml file.
if you want directly to use A16 board, you can download KCS firmware.
note: when you download firmware, remove the RF 433M receiver module from PCB.

Can you please clarify, if I want to use A16 with Home Assistant and ESPHome, is this the yaml file to use?
https://www.kincony.com/kc868-a16-ethern...igure.html

1) The file is badly formatted. Is it available for download with proper formatting?
2) Can you explain where/how to add the file to home assistant installation?
3) Please clarify on the firmware: If I use this one:
https://www.kincony.com/forum/showthread.php?tid=3791
Is this the valid firmware to have the A16 work with ESPHome in Home Assistant?

When I go to ESPHome in Home assistant and click add device, it asks for IP and Port of the device. Should this work with A16?
Reply


Messages In This Thread
RE: how to connect KC868 to home assistant - by jarekD - 06-18-2024, 08:21 PM

Forum Jump:


Users browsing this thread:
1 Guest(s)