07-25-2024, 01:12 PM
Hi ,
i am trying to integrate my KC868-AIO into my loxone system .
i am new to this so i am having some problems.
i have done this so far :
pc and Kincony AIO are connected to the same acces point.
i can acces the AIO tru ESPhome .
when i configure the AIO there i can find the AIO in my wireless network
i was able to connect with the download tool so the firmware V2 could be installed but there i get stuck
the download is succesful
but then i can not do anything .
if i use the scan device tool i can not find the kincony
and the wireless signal of the kincony is gone until i re install it with the esphome "install for first use".
i am sure i am making some silly fault but unexperienced me is stuck at the moment
i am trying to integrate my KC868-AIO into my loxone system .
i am new to this so i am having some problems.
i have done this so far :
pc and Kincony AIO are connected to the same acces point.
i can acces the AIO tru ESPhome .
when i configure the AIO there i can find the AIO in my wireless network
i was able to connect with the download tool so the firmware V2 could be installed but there i get stuck
the download is succesful
but then i can not do anything .
if i use the scan device tool i can not find the kincony
and the wireless signal of the kincony is gone until i re install it with the esphome "install for first use".
i am sure i am making some silly fault but unexperienced me is stuck at the moment