Smart Home Automation Forum › Technical Support › KC868-A6 v
using 5v-12v as input sensor

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
using 5v-12v as input sensor
amararsa24s Offline
Junior Member
**
Posts: 9
Threads: 1
Joined: Sep 2024
Reputation: 0
#4
09-09-2024, 07:08 PM
(09-08-2024, 11:26 AM)admin Wrote: it's dry contact signal of E3F-DS30P1. so just connect to KC868-A6 board's digital input port.

this PNP - Normaly open sensor : the black will output positive voltage signal when object is detected. 
the output voltage is the same as the input 6-36v
[Image: PHI1072896-E3F-DS30P1-PNP-Photoelectric-...pen-02.jpg]
Find
Reply


Messages In This Thread
using 5v-12v as input sensor - by amararsa24s - 09-08-2024, 11:05 AM
RE: using 5v-12v as input sensor - by admin - 09-08-2024, 11:26 AM
RE: using 5v-12v as input sensor - by amararsa24s - 09-09-2024, 07:08 PM
RE: using 5v-12v as input sensor - by amararsa24s - 09-09-2024, 06:10 PM
RE: using 5v-12v as input sensor - by admin - 09-09-2024, 11:03 PM
RE: using 5v-12v as input sensor - by amararsa24s - 09-10-2024, 07:32 AM
RE: using 5v-12v as input sensor - by amararsa24s - 09-11-2024, 05:08 PM
RE: using 5v-12v as input sensor - by admin - 09-11-2024, 11:42 PM
RE: using 5v-12v as input sensor - by amararsa24s - 09-12-2024, 06:31 AM
RE: using 5v-12v as input sensor - by amararsa24s - 09-14-2024, 11:11 PM

Forum Jump:


Users browsing this thread:
1 Guest(s)