Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
relay last state
#1
Hi, I would like to get a KC868-a6 board with the relays to run a home automation project.
The question I have is if it is possible to have the relays resume their last state if there is a power failure or similar.
So if they are reset, they would resume the last known state.

Is this possible and how would I accomplish this,
I have looked at using a MQTT system but I think it would be better if the KC868 board is able to store the state of the relays and then resume the state if reset.
Reply


Messages In This Thread
relay last state - by icemannz - Today, 12:13 AM
RE: relay last state - by admin - Today, 02:34 AM
RE: relay last state - by icemannz - 11 hours ago

Forum Jump:


Users browsing this thread:
1 Guest(s)