01-19-2025, 10:50 AM
(This post was last modified: 01-19-2025, 04:09 PM by vdeconinck.)
Hi,
I bought an A16 to use as my security system (connected to Home Assistant), because it has Ethernet which is immune to Wi-Fi jamming.
I knew thanks to this thread that OTA only worked with WiFi, so my plan was to leave both interfaces up: Ethernet with IP address A for daily (alarm) use and Wi-Fi with IP address B when I need to send an update via OTA.
However, when I try to configure both in ESPHome, I am getting this error:
:-(
How can I update the A16 once installed and use it on Ethernet ? (the A16 will be enclosed in a ceiling, so USB will not be an option once installed)
Kind regards,
Vincent
I bought an A16 to use as my security system (connected to Home Assistant), because it has Ethernet which is immune to Wi-Fi jamming.
I knew thanks to this thread that OTA only worked with WiFi, so my plan was to leave both interfaces up: Ethernet with IP address A for daily (alarm) use and Wi-Fi with IP address B when I need to send an update via OTA.
However, when I try to configure both in ESPHome, I am getting this error:
:-(
How can I update the A16 once installed and use it on Ethernet ? (the A16 will be enclosed in a ceiling, so USB will not be an option once installed)
Kind regards,
Vincent