11-08-2021, 12:50 AM
(11-07-2021, 09:09 PM)leliodm Wrote: Hi,
I just opened and connected by COLB. I am able to visualize the change of status of the DI input ports from the smart board controller app.
I would like to know
1. what is the procedure to update the firmware step by step - I could not find the right thread in the forum, sorry if I missed something
2. I cannot connect to the web interface where to configure the MQTT server - I can only see the interface as attached to this message.
Any help is welcome!
Thanks
Lee
You need connect a network cable ,then find the IP of ethernet and open your browser, you can get the parameters. Like this: