|
M30 CT ratio
|
04-08-2025, 12:34 AM
if you use M16v2 or M30 board, just chose 2000:1 CT clamp sensor, it according to PCB hardware design.
YouTube: https://www.youtube.com/c/KinCony
Online Store: https://shop.kincony.com Alibaba Store: https://kincony.en.alibaba.com/ |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
M30 CT ratio - by Linus68 - 04-07-2025, 02:29 PM
RE: M30 CT ratio - by admin - 04-08-2025, 12:34 AM
RE: M30 CT ratio - by Linus68 - 04-08-2025, 06:49 AM
RE: M30 CT ratio - by admin - 04-08-2025, 08:47 AM
RE: M30 CT ratio - by Linus68 - 04-08-2025, 09:44 AM
RE: M30 CT ratio - by Linus68 - 04-16-2025, 06:25 AM
|
| Users browsing this thread: |
| 1 Guest(s) |
