12-08-2025, 01:08 PM
Hi
I have configured MQTT in home assistant, and connected my KC868-COLB and KC868-H32B boards successfully to home assistant.
I am able to control relay outputs on KC868-H32B, and can see digital inputs on KC868-COLB change when connecting . However Analog Inputs are staying at 0.0V. I am using a 0-5VDC sensor and have confirmed i am getting a valid signal from the sensor using a multimeter (0-2.5 Bar Pressure sensor, reading goes up to 0.5V when i blow into sensor)
I am using YAML code from https://www.kincony.com/mqtt-input-modul...stant.html, with device ID entered in
sensor:
- name: COLB-A1
unique_id: COLB-A1
state_topic: COLB/99e80c000000c11d13155107/state
unit_of_measurement: "V"
value_template: "{{ value_json.A1.value }} "
What else do i need to do to get a reading to register on home assistant?
I have configured MQTT in home assistant, and connected my KC868-COLB and KC868-H32B boards successfully to home assistant.
I am able to control relay outputs on KC868-H32B, and can see digital inputs on KC868-COLB change when connecting . However Analog Inputs are staying at 0.0V. I am using a 0-5VDC sensor and have confirmed i am getting a valid signal from the sensor using a multimeter (0-2.5 Bar Pressure sensor, reading goes up to 0.5V when i blow into sensor)
I am using YAML code from https://www.kincony.com/mqtt-input-modul...stant.html, with device ID entered in
sensor:
- name: COLB-A1
unique_id: COLB-A1
state_topic: COLB/99e80c000000c11d13155107/state
unit_of_measurement: "V"
value_template: "{{ value_json.A1.value }} "
What else do i need to do to get a reading to register on home assistant?