[Arduino IDE demo source code for KC868-AG]--#02 433Mhz receive code

[KinCony Support]

Code 2: //The demo code is 433Mhz receive code   You can copy the code to your Arduino IDE

Code:

#include <RCSwitch.h>

RCSwitch mySwitch = RCSwitch();

void setup() {
  Serial.begin(9600);
  mySwitch.enableReceive(digitalPinToInterrupt(13));// IO13  433 RECEIVE PIN
}

void loop() {
  if (mySwitch.available()) {
   
    Serial.print("Received ");
    Serial.print( mySwitch.getReceivedValue() );
    Serial.print(" / ");
    Serial.print( mySwitch.getReceivedBitlength() );
    Serial.print("bit ");
    Serial.print("Protocol: ");
    Serial.println( mySwitch.getReceivedProtocol() );

    mySwitch.resetAvailable();
  }
}

   
  RF-receiver.zip (Size: 393 bytes / Downloads: 261)