04-04-2022, 05:37 AM
As I wrote in my other post, I connected the push button switch module to rs232 to the LAN converter, I would know if it is possible to change the push button switch module firmware to get a message every time I press and leave a contact from the input like in your video (https://www.kincony.com/momentary-latch-...n-diy.html)
If I press and hold a button I receive RELAY-KEY-255, X, 1,
If I release the button I receive RELAY-KEY-255, X, 0
do you think is possible?
thank you in advance
If I press and hold a button I receive RELAY-KEY-255, X, 1,
If I release the button I receive RELAY-KEY-255, X, 0
do you think is possible?
thank you in advance