06-10-2022, 12:01 AM
if you use KC868-Server for RS485 modbus by Node-Red:
1. Enable serial port on Raspberry Pi CM4
The enable it you need to check in /boot/config.txt the line enable_uart
enable_uart=1
2. use "/dev/ttyS0", not "/dev/ttyAMA0"
today we will upload YouTube video about Node-Red control output by RS485 demo.
1. Enable serial port on Raspberry Pi CM4
The enable it you need to check in /boot/config.txt the line enable_uart
enable_uart=1
2. use "/dev/ttyS0", not "/dev/ttyAMA0"
today we will upload YouTube video about Node-Red control output by RS485 demo.