08-20-2022, 12:50 AM
1. take a photo how you wire switch terminal board with your wall switch.
2. suggest you connect your motor to A16's output. it's easy to set "interlock" mode by A16's ESPHome config file, just change a little code, you can see this video tour, that is demo for E16S, not also can use for A16's setting. https://youtu.be/eEnQ2hHE1JM
3. H32B's input only use for dry contact, can't input ac220v, that will be broken for controller. you can create "automation" in home assistant. let inputX trigger some actions that you can define. just define an "automation" such as relay1 ON, relay2 ON, ...... that trigger with inputX.
4. this also is "automation" function, just "sunrise" and "sunset" created in home assistant as a sensor, then trigger "automation" by this sensor.
5. already given you the video tour, you just do as that video. https://youtu.be/np2JzhAPl3M
2. suggest you connect your motor to A16's output. it's easy to set "interlock" mode by A16's ESPHome config file, just change a little code, you can see this video tour, that is demo for E16S, not also can use for A16's setting. https://youtu.be/eEnQ2hHE1JM
3. H32B's input only use for dry contact, can't input ac220v, that will be broken for controller. you can create "automation" in home assistant. let inputX trigger some actions that you can define. just define an "automation" such as relay1 ON, relay2 ON, ...... that trigger with inputX.
4. this also is "automation" function, just "sunrise" and "sunset" created in home assistant as a sensor, then trigger "automation" by this sensor.
5. already given you the video tour, you just do as that video. https://youtu.be/np2JzhAPl3M