I'm testing some things out.
It works if I create a low-pass filter (converting the PWM signal to a voltage signal).
I also need to put a resistor over the PWM signal.
So I think this proves the board is currently only capable of outputting a PWM signal, not a 0-10v voltage output.
Is there a way to do this, or have I ordered the wrong board?
I really appreciate any help you can provide.
It works if I create a low-pass filter (converting the PWM signal to a voltage signal).
I also need to put a resistor over the PWM signal.
So I think this proves the board is currently only capable of outputting a PWM signal, not a 0-10v voltage output.
Is there a way to do this, or have I ordered the wrong board?
I really appreciate any help you can provide.