Smart Home Automation Forum › Technical Support › KC868-A4 v
Template for KC868-A4 Tasmota

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Template for KC868-A4 Tasmota
VascoTeixeira Offline
Junior Member
**
Posts: 5
Threads: 1
Joined: May 2023
Reputation: 0
#3
05-17-2023, 01:39 AM (This post was last modified: 05-17-2023, 01:41 AM by VascoTeixeira.)
(05-17-2023, 12:40 AM)admin Wrote: your float sensor is dry contact signal, so need use by Digital Input port, not use analog input.
just set digital input port in your tasmota config webpage is ok.

ye im trying to conf it , in tasmota parameterts i need to change GPI14/27/39/36 to what ?

https://prnt.sc/TaRaW5vqTg7l
Find
Reply


Messages In This Thread
Template for KC868-A4 Tasmota - by VascoTeixeira - 05-16-2023, 06:41 PM
RE: Template for KC868-A4 Tasmota - by admin - 05-17-2023, 12:40 AM
RE: Template for KC868-A4 Tasmota - by VascoTeixeira - 05-17-2023, 01:39 AM
RE: Template for KC868-A4 Tasmota - by admin - 05-17-2023, 02:09 AM
RE: Template for KC868-A4 Tasmota - by admin - 05-23-2023, 10:40 PM
RE: Template for KC868-A4 Tasmota - by admin - 05-24-2023, 01:52 AM
RE: Template for KC868-A4 Tasmota - by admin - 05-24-2023, 01:09 PM

Forum Jump:


Users browsing this thread:
1 Guest(s)