(10-19-2023, 12:59 AM)KinCony Support Wrote:(10-18-2023, 05:20 PM)zolax Wrote:(10-18-2023, 05:01 AM)KinCony Support Wrote:(10-17-2023, 12:13 PM)zolax Wrote:(10-17-2023, 10:23 AM)admin Wrote: if you want received 433M signal THEN turn ON relay. IF "condition" chose KC868-AG Pro --> 433M learned signal.
There is no possible to choose KC868-AG-Pro condition. There is only stuff "generated" by it like Window Pusher etc.
Maybe you could make a screen with KC868-AG-Pro selected as a condition. I have newest Tuya version on the phone.
This was possible with A4 but not with AG.
According to your question, I think you can use 3 pieces of KC868-A4, then the wireless signal will be programmed 32*3=96, we ask the tuya support ,it is not support received RF signal to be an if command, tuya app cannot implement the IF command like KC868-A4.
Understand but A4 has only 4 output (have to use this output in tuya), need 16 virtual output on each device so will have 3x16 outputs. I already tried to put firmware from A16 to A4 but it doens't work. Can you help with this?
I don't think I can implement your function: because tuya app does not support learning RF signals as a condition to interact with other functions.
The current scheme is to replace the curtain motor with a 220V motor and use the relay output of KC868-A32 to control the curtain motor
I'm 100% sure it will work because already tested it in KC868-A4. I did if-then using your www menu: for example if recived=signal_1 then set output_1=0 ; if recived=signal_2 set output_1=1. After this I do if-then condition in tuya for example if output_1=0 then close actuator 0 etc. It works with 4 actuators but I need 40.