(11-29-2023, 12:06 AM)admin Wrote: post your yaml file at here, and your esphome LOG screen photo about wifi information.
do you have use dc12v power supply? whether can change another power supply for a testing?
With this "esphome-web-5a54b8_wifi.yaml" that has the wifi configured it gives me these logs: "logs_esphome-web-5a54b8_run.txt". On occasion if you have connected to the wifi but it was only a bar and was not stable sometimes disconnected.
With this "esphome-web-5a54b8_ethernet.yaml" that has the ethernet configured it gives me these logs: "logs_esphome-web-5a54b8_logs_ethernet.txt". I can see the values on HA but after connecting all the clamps and putting a 100w incandescent lamp on channel 1 I don't see any reading. I have 50 -> 1v clamps, the board configured all clamps in volts, the readings it shows are all noise, none gives high values.
Attached is a photo of the assembly
I'm using the dc12v power supply that came with my order from your store, i could look for another one but I have measured the output and it gives 12,16v, it seems correct.
Thanks for your help