relay last state

[icemannz]

Hi, I would like to get a KC868-a6 board with the relays to run a home automation project.
The question I have is if it is possible to have the relays resume their last state if there is a power failure or similar.
So if they are reset, they would resume the last known state.

Is this possible and how would I accomplish this,
I have looked at using a MQTT system but I think it would be better if the KC868 board is able to store the state of the relays and then resume the state if reset.

[admin]

download KCS firmware, there is an option "keep output after restart" , just enable it.

[icemannz]

thanks that is good to know