Reset Board ? product reliability

[jltluc57]

I have the right firmware

All this has already been done.

I use static IPs!

And so there is the same IP since we cannot configure two different ones

[admin]

you can set DHCP for testing.

[LambrosS]

Hello 
I have also the KC868-A16 with the  v2.2.10 firmware and I have the same problem.
As soon as I made any changes and system has to restart the Ethernet port stops to communicate with the switch (led on the switch turns off) and I have to disconnect the supply to the board and reconnect it in order to connect to the card.
I have also turn wifi off but no change.

[admin]

take a video is better.

[LambrosS]

Hello again,
I have enable wifi and select STA mode, put ssid and password. I have also put a static ip on the LAN and restarted the board.
After restarting the board., the Ethernet port was not disconnected from the switch but i couldn't connect to the board.
I removed the ethernet cable from the swich and connected to the boad via Wifi.

From that time i haven't have any disconnection!!!!!

[jltluc57]

Yes I agree, but it is not normal it must take one of the networks.
The ideal is an IP by type of media.
For me the reliability remains the Lan