Pull up on A8

[admin]

digital input use for switch button or any dry contact signal sensor, such as door sensor smoke sensor , window sensor. etc..
S1,S2 ... can use for DS1B20 temperature sensor, or DHT11, DHT22 temperature and humidity sensor.

[heffneil]

Thats what I am using a door switch and its flapping. I have another kincony that is connected to a button and its flapping while I am sleeping. I don't know if this is network causing this bouncing or if the devices are just not reliable.

[heffneil]

No response since after new years. I have big problems again.

[admin]

S1,S2 can use for 1-wire device, such as DS18B20, DHT11,DHT22 sensor.
S3,S3 use for digital input, such as dry contact signal.

[heffneil]

S1,S2 can use for 1-wire device, such as DS18B20, DHT11,DHT22 sensor.
S3,S3 use for digital input, such as dry contact signal.

I am using closed contact / dry contact door sensors.  I should be able to use ground to any of the other inputs, right?

[admin]

yes

[heffneil]

But I am getting terrible inconsistencies on not one but most devices.

[heffneil]

I have 5 of these in production and a box more. I want to return them all. I think in total I have 20. I can't rely on this and I highly recommend anyone who sees this to think twice. I have far too many mission (home) critical devices connected to these boards and I just can't let my septic system get wiped out because this doesn't respond or a flood in my home because the main water valve is unresponsive.