F8 on device physical switches in ESPHome

[Vinceken]

Hi - with esp-idf in ESPHome, how can I access the state of the physical on device switches?

I can't seem to observe those on any GPIO pins.

I would like to configure (in esphome) some of them to control their output relay directly, but for others for them to act as momentary switches. I can manage all the coding myself if I can work out where to observe their state...

Thanks.

[admin]

the switch on the box works without any software and firmware, it's physical, it used in emergency situations, even if controller is broken.
if you want use switch panel , you should connect to digital input ports with momentary switch, that will feedback relay state.