Is any way to link elecyric gate motor and wireless security alarm to use kincony app

[ahmed]

Is any way to link electrc gate motor and wireless security alarm to use kincony app?

The wirless security alarm is :-  SL6 Response Wirefree Telecommunicating Alarm System 868 MHZ
And the electric gate motor is 433MHZ RF , i attached the specifications and details

[admin]

you can see this video, may be is your wanted. just short for relay controller's sensor input ports, then will send alarm message to your mobile phone.

[ahmed]

The gate motor is RF 433MHZ, is any way to learn to kincony and open, close the gate from the same app?

[admin]

do you gate motor receiver PCB board or controller have a "learn" function button?

[ahmed]

Yes, the remote control is 433 MHZ learn function button.

[admin]

ok, use KC868-G wireless gateway to send RF 433MHz signal. you can use kincony smart home app create a "RF" button, when press the "button" on phone will send a RF signal, then let your gate motor pcb board "learn" the signal to remember it.

[ahmed]

Where the KC868- G wirless will be located
Baring in mind the gate automation panel on the house fence outdoor .

[admin]

not far away from your gate receiver module. near by it. KC868-G only connect with a USB cable for DC5V power supply is ok.

[ahmed]

Not sure the best location of the KC-868-G
?

The gate receiver is close to gate on the fence.
All controllers will be in garden switchboard.

[admin]

let KC868-G distance with your receiver board <10 meter.