Hello! Is it possible to connect COL and Domoticz?

good morning, i wanted to install the power meter for COL. I saw that it communicates with COL in bus 485. through ifttt is it possible to program the outputs commanded at certain read power values? Does COL also accept other peripherals connected on the 485 bus? thanks

Dear Admin.

Need some advice on which product that you have to control a maximum of 4 pumps where the logic are as per below:

1. Turn "ON" first pump
2. After 30min of pumping turn "OFF" pump 1
3. After 5min of pump 1 in "OFF" condition, Turn "ON" pump 2
4. After 30min of pump 2 running "ON" condition, turn "OFF" pump 2

Could you please suggest which product that you have that can help me do the above?

Dear Admin I would like to connect 2remote controller from button switch board to operate only channel from 1-16 outputs. i don't need to use other outputs.
On the video You show how to add 2 remote controller to use all outputs. Please help with this solution.

Attached Files

Thumbnail(s)
   

if you have create the webpage on your own server by Node-Red, now this tour will help you to make a own android app from webpage.
we have write the lesson step by step using android studio.

  how to make android app from website.pdf (Size: 2.18 MB / Downloads: 5183)

"KSmart" android phone app function as same as "KinCony smart home" app, just changed the app name , ico and startup page in app. without KinCony's LOGO for project distributor.

here is download link: https://www.kincony.com/download/KSmart.apk

Create the website connect with your own server and remote control 8 channel dimmer output.

  KC868-D8-AWS-EC2.zip (Size: 1.97 KB / Downloads: 1016)

Create the website connect with your own server.
1. send RF433MHz command for wireless switch panel
2. send IR signal command to control IR device (like TV, DVD, Air conditioner, Fan .....  any have IR remoter's device)


  KC868-G-WiFi-Controller-AWS-EC2.zip (Size: 11.78 KB / Downloads: 1007)

I had created a simple flow within my home assistant using toggle switch to control few switches. The switch work normally only if the switches are turn on/off one by one but when simultaneous actions triggered, only few switches are turn on/off. I attach a video for this scenario. 

Could anybody suggest a better way to make a parallel/simultaneous actions work.

Node-red flow diagram
   

here is node running on Node-Red by Raspberry pi4 to control one relay ON/OFF by USB port. (use USB-RS232 convert cable) suit for all model of KC868 relay controller.

  KC868-Relay-Controller-USB-RS232.zip (Size: 2.98 KB / Downloads: 1099)