Dear Admin.

How do i change the icon layout on NodeRed Dashboard. Please find screen shot. 
If i want to move the 1st LED beside the 1st Switch and move the 2nd LED beside the 2nd switch how do i do it?

Attached Files

Thumbnail(s)
   

1. Add support KC868-D8 dimmer controller. Now you can use for LED strip or lamp change brightness and control motor or fan speed.
2. Improve the control speed of relay controller.

Download link: https://www.kincony.com/download/kbox-sm...201104.apk

KC868-COL locks up and does not respond in the morning or if left for a long period.  I get the following messages:
"Kincony smart controller V.10.303.build 805 (not responding)
JKE_Test not responding (in Task Manager)
If I end the program in task manager and re-load it works fine until next morning and then same problem
Computer Sleep is set to "never"
Any recommendations? 
James

Dear Sir.

What would your recommendation be if I want to run 7 of the KC868-H32W relay board's?
Can the NodeRed handle all 7 Boards reading all the 224 relays ? 

I have tried the Demo VB application but that only allows to open 1 application for 1 KC868-H32W relay board's and monitor 32 relays as such i can only monitor 1 KC868-H32W relay board at a time.

If i want to have one screen layout for all 7 KC868-H32W relay showing me at one time what application do you recommend?

Dear Sir.

I managed to use the IFTTT on the KC868-COL logical controller. 
A very simple test where if the Temperature shows above 33degC Relay 1 turns on at the KC868-H32 relay board's. Both KC868-H32 relay board's and  KC868-COL logical controller are connected via a RS232 cable.

How do show the status of Relay 1 on the KC868-H32 relay board's using a LED on the NodeRed to indicate it's turned "ON"? i don't want to use a Digital in as its a waste of resource. Just a LED on NodeRED reading from the "Function" Node where when its "ON" Led lights up on the NodeRed Screen and when "OFF", LED turns off.

Regards
Subas

Attached Files

Thumbnail(s)
   

Do the relays support inching switching? I need the relay to turn on for 1 second and then automatically turn off.

Answer: Controller's inching switching function support by software. You can create scene mode in our "KinCony smart home" phone app. Also we have "KBOX" local network version app, that can set button for "CLICK" or "TOUCH" mode, that works without internet.

I have a h32b smart controller and yesterday i configured and connected it back up today to continue configuring it and i cann see it on the network anywhere, is there a reset button or will i have to configure it via the rs232 port.

Many thanks in advance

Gary

3 computer for install, record HDMI video, monitor the network.